4×4 Linesman Crane Truck

Posted on June 22, 2015 Updated on September 5, 2015

IMG_7719IMG_7724
IMG_7726IMG_7733IMG_7743

OTEL engineer Dan Matoka has just finished fabricating this good looking body and crane fit out on this new Isuzu FTS800 4×4 chassis for Northpower which will be based out of Whangarei, Northland…

It has a Palfinger PK15500C crane and is equipped with radio remote controls and a hydraulic hose reel for the 500mm and 600mm earth auger with 1 metre extension and hydraulic drive motor that is stored on the deck. It also has a front outrigger beam with hydraulic legs.

The deck features Aluminum hinging sides for weight savings and a special non skid deck coating for safety. Also fabricated into the body design is a under deck toolbox, Lt hand wash and soap dispenser, earth rods, certified tow-bar, storage hooks, Lt emergency water container and in built load anchorage tie down points. It also has a front mounted Holland pintle hook off a certified tow-bar assembly to help in the event of being stuck. LED lights are fitted with roof beacons and K&H remote control work lamps on the cab roof.

It is also fitted out with large off road rims and tires and runs as a Category 1 over dimensional vehicle because of its width and specially fabricated over width rear mudguards with over dimension hi-vis decals encase the large off road rear wheels.

It has been sandblasted and finished with Resene two pack paint to clients fleet colours.

For more information contact us direct to discuss your requirements.

Leave a Reply